-Vfc gearbox shell -FLT bushings jb welded into gearbox. -Shs m120 spring, -shs piston (aoe corrected), -shs mushroom piston head, -shs bore up cylinder head, -Maxx model ribbed and ported cylinder, -Maxx model nozzle 21mm, -king arms Tappet plate, -13:1 Prometheus wide use gears, -AIM anti reversal latch (doesn’t pop out during disassembly), -Perun v2 (for some reason doesn’t allow me to go into programming mode and has three round burst and full auto, no semi, wires that were stripped and have shrink wrap around them), -Maxx model adjustable trigger, -Lonex a1 supreme edition motor 45k, pts motor grip (shaved down, may need more shaving down) Motor is stuck in grip, but you can use pliers to just wiggle it out. -Maxx model/EMG hopup and nub with 6.03 angel customs stainless steel barrel and modify flat hop bucking (no issues with barrel setup, shoots pretty far, 200ft no problem) -King arms black rain ordnance billet style receivers (I’m pretty sure these are rare) with missing parts (main receiver pins are still there along with mag release; trigger pin and anti roll pins are missing, charging handle broke) , loose pts zev technologies mlok handguard. Shimming seems okay, sound wonky and probably needs a reshim. Will not include tracer unit, flashlight, rails, flip up sights, and stubby foregrip. A steal if you can tech and you can probably profit off of. Internal parts appear to be in good working condition; I’m just selling because I realize teaching isn’t for me. Just buying a pre built gun at this point. It’s been a headache and I really don’t have time for it. Photo has EMG gears in it and an a tech innovations cylinder head; I had issues with both so I replaced them with the above mentioned parts.