Replacement Paddle Wheel for Odin M12 Sidewinder Speedloader - 3 PACK $10 ONLY INCLUDES THE 3D PRINTED BLACK PLASTIC, DOES NOT INCLUDE THE SPEEDLOADER OR ANY OTHER PARTS. Ok, you load in your new EPM1 and then your trusty odin speedloader slips. You open it up to find that the wheel responsible for loading in the BBs deformed, what do you do now? That's where a 3d printer comes into play. Simply dissemble the crank and put the existing bolt into the new one and start loading away! You get 3 of them since these are consumables. *PLEASE SET THE CLUTCH PROPERLY TO AVOID DESTROYING THE WHEEL! This is by no means stronger than the original nylon that it comes with, although it does withstand wear and tear, even Odin Innovations themselves strongly against fully tightening the nylock nut. There is a good guide on their website: odininnovations.com/troubleshooting * PTS EPM1 OWNERS: As a owner of 7 of the new 250 round and the short 170 round midcaps, DO NOT EXPECT TO FULLY LOAD THEM AS SOON AS YOU GET THEM. All midcaps require a "break-in" period where a brand new spring needs to decompress to it's right form. This happens naturally with loading mags and using them. You can just keep loading them until the clutch slips and then unload it back into the speedloader, but whatever you do, DO NOT TIGHTEN THE CLUTCH TO FULLY LOAD A MIDCAP. Fastest way to ever break your Odin. CURRENTLY ONLY HAVE BLACK COLOR Will discount on 2 or more purchases